EasyManua.ls Logo

IK Multimedia AmpliTube X-SPACE - MAGNETIC

IK Multimedia AmpliTube X-SPACE
49 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AmpliTube X-SPACE
Reverb Models
36
MAGNETIC
This is a spatial reverb that has an airy tone with an accentuated modulation effect, which at low rates creates
an effect of space floating.
Parameters
• TIME: controls the reverb tail length.
From 0.8 s to 12 s.
• PRE-DELAY: controls the pre-delay amount.
From 0 ms to 1000 ms.
• COLOR: controls the frequency response of the reverb. At minimum the reverb gets darker, at maximum
the reverb gets brighter. Set in the middle the reverb is flat.
From -10 dB to +10 dB.
• MOD: controls the amount of modulation of the reverb.
From 0% to 100%.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• MOD RATE: controls the rate of the reverb modulation.
From 0 to 100.
• MOD COLOR: set the frequency zone where the modulation is acting.
From -10 to +10.
• X-MODE: engages the most possible tail length.
ON or OFF.
MAGNETIC Control Changes
Parameter Control Change # Values
TIME 21 0 – 127
PRE-DELAY 22 0 – 127
COLOR 23 0 – 127
MOD 24 0 – 127
MIX 25 0 - 127
MOD RATE 46 0 - 127
MOD COLOR 47 0 - 127
X-MODE 13 0 - 127
When a parameter range is not linear its values are equally divided among the 128 steps of a Control Change
value.

Related product manuals