IK Multimedia AmpliTube X-SPACE - EARLY REF

AmpliTube X-SPACE
Reverb Models
32
EARY REF
This model emulates the typical short reflections that can be heard in a small room or space. It’s fully
customizable to bring it from a sort of traditional delay to a buzzing early reflection sound.
Parameters
• TIME: controls the reverb tail length.
From 0.1 s to 0.8 s.
• PRE-DELAY: controls the pre-delay amount.
From 0 ms to 100 ms.
• COLOR: controls the frequency response of the reverb. At minimum the reverb gets darker, at maximum
the reverb gets brighter. Set in the middle the reverb is flat.
From -10 dB to +10 dB.
• MOD: controls the amount of modulation of the reverb.
From 0% to 100%.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• HPF: controls the cut-off frequency of the high-pass filter.
From 22 Hz to 1000 Hz.
• MOD RATE: controls the rate of the reverb modulation.
From 0.1 Hz to 7 Hz.
• SIZE: controls the dimension of the ambience from which the reverbs is generated.
From 50% to 200%.
• X-MODE: engages the most possible tail length.
ON or OFF.
EARLY REF Control Changes
Parameter Control Change # Values
TIME 21 0 – 127
PRE-DELAY 22 0 – 127
COLOR 23 0 – 127
MOD 24 0 – 127
MIX 25 0 - 127
SIZE 46 0 - 127
HPF 47 0 - 127
MOD RATE 48 0 - 127
X-MODE 13 0 - 127
When a parameter range is not linear its values are equally divided among the 128 steps of a Control Change
value.