IK Multimedia AmpliTube X-SPACE - GATE

AmpliTube X-SPACE
Reverb Models
29
GATE
This is a customizable gated reverb that cuts off the reverb trail as desired in order to add textured groove to
your playing.
Parameters
• TIME: controls the reverb tail length.
From 0 s to 0.6 s.
• PRE-DELAY: controls the pre-delay amount.
From 0 ms to 1000 ms.
• COLOR: controls the frequency response of the reverb. At minimum the reverb gets darker, at maximum
the reverb gets brighter. Set in the middle the reverb is flat.
From -10 dB to +10 dB.
• MOD: controls the amount of modulation of the reverb.
From 0% to 100%.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• HPF: controls the cut-off frequency of the high-pass filter.
From 22 Hz to 1000 Hz.
• MOD RATE: controls the rate of the reverb modulation.
From 0.5 Hz to 10 Hz.
• SIZE: controls the dimension of the ambience from which the reverbs is generated.
From 0% to 100%.
• X-MODE: engages the maximum time and size producing a dramatic timbre change.
ON or OFF.
GATE Control Changes
Parameter Control Change # Values
TIME 21 0 – 127
PRE-DELAY 22 0 – 127
COLOR 23 0 – 127
MOD 24 0 – 127
MIX 25 0 - 127
HPF 46 0 - 127
MOD RATE 47 0 - 127
SIZE 48 0 -127
X-MODE 13 0 - 127
When a parameter range is not linear its values are equally divided among the 128 steps of a Control Change
value.