IK Multimedia AmpliTube X-SPACE - SHIMMER 2

AmpliTube X-SPACE
Reverb Models
13
SHIMMER 2
Shimmer 2 differs from the first one because there is no buildup in the feedback and the two different pitched
voices can be set in parallel to create custom harmonizations.
Parameters
• TIME: controls the reverb tail length.
From 6 s to 20 s.
• PRE-DELAY: not available.
• COLOR: controls the frequency response of the reverb. At minimum the reverb gets darker, at maximum
the reverb gets brighter. Set in the middle the reverb is flat.
From -10 to +10.
• MOD: controls the amount of modulation of the reverb.
From 0% to 100%.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• SHIFT 1: controls the pitch of the note generated by the shimmer of the first voice. It can be set to perfect
pitch or fine-tuned with 1/8 of a tone.
From -12 semitones to +12 semitones.
• GAIN 1: controls the level of the first voice.
From 0 to 10.
• SHIFT 2: controls the pitch of the note generated by the shimmer of the second voice. It can be set to
perfect pitch or fine-tuned with 1/8 of a tone.
From -12 semitones to +12 semitones.
• GAIN 2: controls the level of the second voice.
From 0 to 10.
• SIZE: controls the dimension of the ambience from which the reverb is generated.
From 50% to 150%.
• MOD RATE: controls the rate of the reverb modulation.
From 0.1 Hz to 7 Hz.
• MODE: chooses among 3 modes.
• DUAL: the shimmer offers both pitched voices.
• SINGLE: the shipper offers only the first pitched voice.
• NO PITCH: the shimmer offers its characteristics without the pitched voices.
• X-MODE: engages the most possible tail length.
ON or OFF.