English
23
“Channel 1” makes only input 1 channel to reach the direct monitoring path on both L and R sides.
“Channel 2” makes only input 2 channel to reach the direct monitoring path on both L and R sides.
These are useful when only one input is normally used and you don’t want even the slightest amount of noise
coming from the other channel to be mixed into the monitoring path.
Audio Input section:
Here you can see the input channels active source (Instruments, Mic or Line) and monitor the level on high
precision peak meters.
You can also switch phantom power on and off. Remember that phantom power is activated on both channels
at the same time. It is NOT possible to enable phantom power on one input channel only.
However, phantom power will only be applied to the XLR input.
Audio Output section:
Here you can see the output channels levels on precision peak meters, you can adjust the output levels of all
outputs with the large sliders, or you can quickly mute each output individually.
Amp Output GND LIFT:
The Amp Output is a specially designed floating output made to drive amplifiers and sensitive vintage stomps
without the typically associated ground loop noises, hum and buzzes. Depending on what else is connected to
the AXE I/O and what grounding scheme is implemented in the setup the amp connection can be cleaner with
GND LIFT active or not active.
The default position is GND LIFT, with lift active, in case you hear some buzz or noise when connecting an high
gain guitar amp, try switching off the GND LIFT.
To Next Page
Loading...
Need help?
General
