English
22
8.1 Interface view
INTERFACE view:
Configuration section:
State:
This LED shows when an AXE I/O unit is connected and active.
MIDI IN, OUT: these LEDs shows when there is MIDI activity on the AXE I/O physical MIDI ports.
Sample Rate:
Here you can set the working samplerate for the AXE IO unit, from 44.1 to 192 kHz.
Remember than in most cases DAWS and host applications will most likely control this value by their end, not
allowing it to be forced differently. For this reason you might see this value to go back to its previous state when
you attempt changing it.
Direct Monitoring:
Here you can determine how the two input channels are mixed on the Direct monitoring path.
“Mono” means that both channels are mixed to mono. This is the most useful setting when you want to monitor
one channel per time as this way the input channel will be monitored on both channels of your monitors or
headphones.
“Stereo” mean that channel 1 will be routed to the left side of your monitors or headphones, and channel 2 on
the right side. This is the most useful setting when you need to monitor stereo sources, like stereo microphones,
keyboards, sound modules etc.
To Next Page
Loading...
Need help?
General
