English
14
When iRig Stomp I/O is in looper mode, the 4 footswitches act as:
Footswitch Function Message sent
SW 1 Selects previous track CC#28 and CC#58 when holding for >1 sec.
SW 2 Selects next track CC#29 and CC#59 when holding for >1 sec.
SW 3 Start-Stop recording/stop playback
of the selected track
CC#30 and CC#60 when holding for >1 sec.
SW 4 (Holding for >1sec.) Delete selected track CC#31 and CC#61 when holding for >1 sec.
MIDI CH 1
Footswitch LED 3 shows you the status of the track:
Function LED status
Track armed LED blinking (red)
Track in recording LED steady on (red)
Track in playback LED steady on (green)
Track empty LED off
Track recorded but not in
playback
LED blinking (green)
3.6 Tuner
Switch combination Function MIDI message sent
Holding Switch 3 >1sec. Tuner On CC#32 – toggle mode
MIDI CH 1
To access the AmpliTube tuner press and hold footswitch 3 for more than 1 second (to exit the Tuner press any
of the 4 footswitches).
To Next Page
Loading...
Need help?
General
