IK Multimedia iRig Stomp I/O - Tap Tempo; MIDI IN;OUT Ports; 4 Audio;MIDI Interface and Foot Controller; Using Irig Stomp I;O as a Generic MIDI Controller

English
15
When iRig Stomp I/O is in tuner mode the footswitche’s LEDs show the tuning status.
Tuning LED status
Note tuned LEDs 2 and 3 turned on (green)
Note low in tune LED 2 turned on (red)
Note very low in tune LED 1 and 2 turned on (red)
Note up in tune LED 3 turned on (red)
Note very up in tune LED 3 and 4 turned on (red)
3.7 Tap tempo
Switch combination Function MIDI message sent
Holding Switch 4 >1sec. Tap tempo On/Off CC#41 – toggle mode
MIDI CH 1
To access the AmpliTube tap tempo press and hold footswitch 4 for more than 1 second (to exit press switch 1,
2 or 3). When iRig Stomp I/O is in tap tempo, use the footswitch 4 to tapping the tempo. Each pression of the
Switch 4 will send a Sysex:
0xF0 0x7E 0x00 0x21 0x1A 0x01 0x03 0x41 0x50 (0x31 0x32 0x33 0x34)* 0xF7
* (example) corresponding to 132,4 bpm
3.8 MIDI IN/OUT ports
With AmpliTube running you can use the physical MIDI IN/OUT ports to send or receive MIDI messages from/to
external MIDI devices.
On the MIDI OUT port will be sent all the MIDI messages generated by the iRig Stomp I/O; the MIDI IN port will
send the MIDI messages to AmpliTube.
4 Audio/MIDI interface and foot controller
4.1 Using iRig Stomp I/O as a generic MIDI controller
With a generic host (i.e: without AmpliTube), you can use iRig Stomp I/O as a generic MIDI controller. This allows
you to send generic MIDI messages to the host. As generic controller you can use the default and the stomp
mode: the looper and the tuner mode will not work.
USB MIDI port
Make sure to have selected “iRig Stomp IO Port 1” as MIDI IN/OUT port.