IKEA TORSBODA - Basic operation; Switching on the appliance; Setting a programme; Setting additional functions

22
Removing tableware
WARNING
Risk of injury!
● Hot tableware can cause burns to the skin. When hot,
tableware is sensitive to shock, may crack and can result
in injury.
● When the programme has ended, do not empty the appli-
ance until the tableware has cooled down for a while.
1. To prevent water dripping on the tableware, unload it
starting at the bottom and working up.
2. Check the washing tank and accessories for soiling and
clean if necessary.
→"Cleaning and servicing", Page24
Basic operation
Basic operation
Basic operation
Switching on the appliance
●
Press ⁠.
The Eco 50° programme is set by default.
The Eco 50° programme is especially environmentally
friendly and ideal for normally soiled tableware. It is the
most efficient programme for the combination of energy/
water consumption for this type of tableware and evid-
ences conformity with the EU Ecodesign Directive.
If you do not perform any actions on the appliance for 10
minutes, the appliance will automatically switch off.
Setting a programme
To adjust the washing programme to the soiling level of the
tableware, select a suitable programme.
● Press the right programme button.
a The programme is set and the programme button
flashes.
a The remaining running time of the programme appears
on the display.
Setting additional functions
You can set additional functions to complete the washing
programme selected.
Note:The additional functions which can be used depend
on the programme selected.
● Press the button for the relevant additional function.
→"Additional functions", Page14
a The additional function is set and the additional function
button flashes.
Setting timer programming
You can delay the start of the programme by up to 24hours.
1.
Press ⁠.
a "h:01" appears in the display.
2.
Use to set the required start time for the programme.
3.
Press ⁠.
a This activates timer programming.
Tip:To deactivate timer programming, press repeatedly
until "h:00" appears in the display.
Starting the programme
●
Press .
a The programme has ended when the display shows
"0h:00m".
Notes
● If you want to add more tableware while the appliance is
running, do not use the tablet collecting tray as a handle
for the top basket. You might touch the partially dissolved
tablet.
● You can only change a programme when running if you
cancel it.
→"Terminate programme", Page22
● The appliance switches off automatically 1minute after
the end of the programme to save energy. If you open the
appliance door immediately after the programme has
ended, the appliance will switch off after 4 seconds.
Interrupting programme
Note:When you open the appliance door once the appli-
ance has heated up, leave the door slightly ajar for a few
minutes and then close it. This will help prevent excess pres-
sure building up in the appliance and stop the appliance
door bursting open.
1. Open the appliance door carefully.
2.
Press ⁠.
a The programme is saved and the appliance switches off.
3.
Press to resume the programme.
4. Close the appliance door.
Terminate programme
To end a programme early or to switch from a programme
that has already started, you will need to cancel it first.
1. Open the appliance door.
2.
Press for approx. 4seconds.
3. Close the appliance door.
a The programme is cancelled and ends after approx.
1minute.
Switching off appliance
1. Please note the information on "Safe use" →Page8.
2.
Press .
Tip:If you press during the wash cycle, the programme
currently running will be interrupted. When you switch the
appliance back on, the programme continues automatically.