23
Basic settings
Basic settings
Basic settings
You can configure the basic settings for your appliance to meet your needs.
Overview of basic settings
The basic settings depend on the features of your appliance.
BASIC SETTING DISPLAY TEXT SELECTION DESCRIPTION
Water hardness H04
1
H00 - H07 Set the water softening system to your water
hardness.
Level H00 switches the water softening sys-
tem off.
Rinse aid dispensing r05
1
r00 - r06 Set the amount of rinse aid to be dispensed.
Switch the rinse aid system off with level r00.
Intensive drying d00
1
d00 - d01 The temperature is increased during the final
rinse, which improves the drying result. This
may increase the run time slightly.
Note:Not suitable for delicate items of table-
ware.
Switch Extra Dry on "d01" or off "d00".
Hot water A00
1
A00 - A01 Set cold water or hot water connection. Only
set the appliance to hot water if this can be
prepared with little energy and a suitable in-
stallation is available, e.g. solar heating sys-
tem with circulation line. The water temperat-
ure should be at least 40°C and max. 60°C.
Switch hot water on "A01" or off "A00".
Interior lighting E02
1
E00 - E02 Interior light.
● With the setting "E00"m the interior light is
switched off.
● With the setting "E01", the interior light can
be activated via the ON/OFF button.
● With the setting "E02", the interior light
goes on when you open the appliance
door.
When the appliance door is opened, the in-
terior lighting switches off automatically after
10 minutes.
Time-beam-on-floor S01
1
S00 - S01 Switch Time-beam-on-floor on or off.
While the programme is running, status in-
formation is projected onto the floor below
the appliance door relating to timer program-
ming, the programme or the time remaining.
If the base panel is pulled forwards or if the
appliance is installed at eye level with the cab-
inet front fitted flush, the display is not vis-
ible.
Level "S00" switches the Time-beam-on-floor
of.
Tone volume b02
1
b00 - b03 Adjustment of tone volume.
Level "b00" switches the signal tone off.
If the Eco drying function is activated, the end
of the programme is not indicated by an aud-
ible signal tone.
1
Factory setting (may vary according to model)
To Next Page
Loading...
