IKEA TORSBODA - Automatic door opening; Installation and connection; Scope of supply; Installing and connecting the appliance

9
Automatic door opening
The appliance door opens automatically during the drying
phase. This ensures a particularly economical drying result.
For best drying results wait until the end of programme be-
fore unloading the tableware. The programme has ended
when the display shows "0h:00m".
If automatic door opening is deactivated, energy consump-
tion increases and the drying phase is usually shortened.
→"Overview of basic settings", Page23
Installation and connection
Installation and connection
Installation and connection
To ensure proper operation, connect the appliance to the
power and water supply correctly. Observe the specified cri-
teria and the installation instructions.
Scope of supply
After unpacking all parts, check for any damage in transit
and completeness of the delivery.
If you have any complaints, contact IKEA or our Customer
Service.
Note:The appliance has been tested at the factory to check
it is in working order. It is possible that water has left marks
on the appliance. These marks will disappear after the first
wash cycle.
The delivery consists of the following:
● Dishwasher
● Operating instructions
● Installation Instructions
● Installation material
● Steam guard plate
● Salt filling aid funnel
● Mains cable
Installing and connecting the appliance
You can position your built-under or integrable appliance in
a fitted kitchen between wooden and plastic walls. If you
subsequently install your dishwasher as a free-standing ap-
pliance, you must stop it from tipping over, e.g. by screwing
it to the wall or installing it under a continuous worktop that
is securely connected to adjacent cabinets.
1. "Follow the safety instructions." →Page4
2. "Follow the instructions for electrical connection."
→Page9
3. Check the Scope of supply and the condition of the appli-
ance.
4. Consult the installation instructions for the installation di-
mensions required.
5. Make the appliance level using the height-adjustable feet.
Make sure that the appliance is standing on the floor se-
curely.
6. "Install the drainage connection." →Page9
7. "Install the drinking water connection." →Page9
8. Connect the appliance to the power supply.
Drainage connection
Connect your appliance to drainage connection so dirty wa-
ter is discharged via the wash cycle.
Installing the drainage connection
1. Consult the installation instructions supplied for the steps
required here.
2. Connect the wastewater hose to the outlet connection of
the siphon using the enclosed parts.
3. When doing so, check that the wastewater hose is not
kinked, crushed or twisted.
4. Also check that there is no cover in the drainage system
preventing the wastewater from being discharged.
Drinking water connection
Connect your appliance to a drinking water connection.
Installing the drinking water connection
Note
● If you are replacing the appliance, you must use a new
water supply hose.
1. Consult the installation instructions supplied for the steps
required here.
2. Connect the appliance to the drinking water connection
using the enclosed parts.
Observe the Technical data.
3. When doing so, check that the drinking water connection
is not kinked, crushed or twisted.
Electrical connection
Connecting the appliance to the electricity supply
Notes
● Please follow the "Safety instructions" →Page4.
● Connect the appliance to alternating current only, in the
range of 220 - 240V and 50Hz or 60Hz.
● Please note that the water safety system is only functional
if there is a power supply.
1. Insert the non-heating appliance plug of the power cable
into the appliance.
2. Insert the mains plug of the appliance into a nearby
socket.
The connection data for the appliance can be found on
the rating plate.
3. Check that the mains plug is inserted properly.