IKEA TORSBODA - Washing results

29
FAULT CAUSE TROUBLESHOOTING
A different error code appears in
the display window.
E:01-00 to E:90-10
A technical fault is present. 1.
Press .
2. Unplug the appliance or switch off the fuse.
3. Wait at least 2minutes.
4. Insert the mains plug of the appliance in a
socket or switch on the fuse.
5. Switch the appliance on.
6. If the problem occurs again:
● Press ⁠.
● Turn off the water tap.
● Pull out the mains plug.
● Contact Customer Service and give the
error code.
Washing results
FAULT CAUSE TROUBLESHOOTING
Tableware is not dry. No rinse aid used or dosage set too
low.
1. Add "Rinse aid" →Page18.
2. Set the amount of rinse aid to be dispensed.
→"Setting the amount of rinse aid", Page19
Programme or programme option
has no drying phase, or the drying
phase is too brief.
● Select a programme with drying, e.g. intens-
ive, strong or ECO programme.
Some option buttons decrease the drying
result, e.g varioSpeed.
Water collects in recesses of the
tableware or cutlery.
● Position tableware at an angle where pos-
sible.
The combined detergent used has
a poor drying performance.
1. Use rinse aid to improve drying performance.
2. Use a different combined detergent with a
better drying performance.
Extra Dry not activated to improve
drying performance.
● Activate Extra Dry.
Tableware removed too early or
drying process not yet ended.
1. Wait until the programme ends.
2. Only remove tableware 30minutes after the
programme has ended.
Rinse aid used has a limited drying
performance.
● Use a name-brand rinse aid.
Eco products may have limited effectiveness.
Appliance door does not open auto-
matically at the end of the pro-
gramme
● Adjust the appliance door as described in the
installation instructions.
The door gap must be at least 70mm -
100mm.
Plastic tableware is not dry. Not a fault. As plastic does not
store heat so well, it also does not
dry as well.
● No remedial action possible.