IKEA TORSBODA - Clean wastewater pump; Transportation, storage and disposal; Removing the appliance; Protecting appliance from frost

35
Clean wastewater pump
Large remnants of food or foreign bodies can block the
waste water pump. As soon as the rinsing water no longer
drains properly, the waste water pump must be cleaned.
WARNING
Risk of injury!
● Sharp and pointed objects or fragments of glass may
block the waste water pump and cause injury.
● Remove any foreign bodies carefully.
1. Disconnect the appliance from the power supply.
2. Remove the top and bottom basket.
3. Remove the filter system.
4. Scoop out any water.
Use a sponge if necessary.
5. Prise off the pump cover using a spoon and grip it by the
crosspiece.
6. Lift the pump cover inwards at an angle and remove.
a You can now reach the impeller with your hand.
7. Remove any remnants of food and foreign bodies in the
area of the impeller.
8.
Insert the pump cover and press down ⁠.
1
2
a The pump cover clicks into position.
9. Install the filter system.
10. Insert the top and bottom basket.
Transportation, storage and disposal
Transportation, storage and disposal
Transportation, storage and disposal
Removing the appliance
1. Disconnect the appliance from the mains power supply.
2. Turn off the water tap.
3. Detach the drainage connection.
4. Detach the drinking water connection.
5. Loosen any screws fastening the appliance to cabinet
parts.
6. Remove the base panel if fitted.
7. Pull the appliance out carefully, along with the hose be-
hind it.
Protect appliance from frost
If there is a risk of frost where the appliance will be standing,
e.g. in a holiday home, empty the appliance completely.
● Empty the appliance.
→"Transporting the appliance", Page35
Transporting the appliance
To avoid damage to the appliance, empty it before trans-
porting.
Note:Always transport the dishwasher upright to prevent
residual water getting into the machine's controls and dam-
aging the appliance.
1. Remove tableware from the appliance.
2. Secure loose parts.
3. "Switch on the appliance." →Page22
4. Select the programme with the highest temperature.
→"Overview of programmes", Page13
5. "Start the programme." →Page22
6. To drain the appliance, terminate the programme after
approx. 4minutes.
→"Terminate programme", Page22
7. "Switch off the appliance." →Page22
8. Turn off the water tap.
9. To empty the residual water out of the appliance, detach
the supply hose and let the water drain out.