Product Operating
Steep
Mode:
The
robot
is
switched
on, the
Light
is
off,
the
robot
is in
still status.
Select Mode:
The
robot
is
switched
on, the
Green color
light
flashes;
the
robot
is in
still
status.
Clean
Mode:
The
Robot
is
working,
the
Green color
light
turned
on
solid.
Switch
On /
Select
/
Sleep
1>.
Switch
On
A.
Make sure
the
power switch
is on
B.
Press CLEAN button
on
main body
or on
remote control
to
start cleaning.
Note:
If
robot
is in
sleeping mode, press CLEAN button
to
wake
up the
robot from sleeping
mode.
Then press CLEAN again,
the
robot starts cleaning automatically.
2>
Select
To
change
robot from cleaning mode
to
selected mode,
the
robot will pause without
work
A.
Press
the
CLEAN button
on the
robot body
or on the
remote control when
the
robot
is
in
cleaning mode
Note:
When robot
is in the
select mode, press CLEAN button
to
make robot
to
re-start
cleaning.
3>.
Sleeping
To
turn robot into sleeping mode from selected mode:
A.
Keep pressing
CLEAN
on
main body
for 3
seconds.
B.
Robot
will
automatically enter sleeping mode
if no
command received
in
15
seconds.
Schedule
Clean
You
can
schedule
to let the
robot start cleaning from
a
certain
time.
Note: Remember
to
re-set
the
clock
time
and
schedule once replace
the
battery
of the
remote control.
Once
the
clock time
is
set,
any
scheduling
you
have
set
will make robot
work
on the
scheduled time.
Setting
the
clock time
1
.Point
the
remote control
towards
the
robot (ensure
the
robot power switch
is
on).
2.Press
CLOCK button
and
then
use
directional buttons
to set the
correct time.
3.Press
CLOCK button again
to
save
the
setting.
To
cancel,
set the
number
to
"00:00".
Setting
a
schedule
The
robot
will
always work
at the
scheduled time unless power switch
of the
robot
is
turned
off.
1
.Point
the
remote towards
the
robot,
(ensure
the
robot power switch
is
on).
2.Press
PLAN
button
and
then
use
directional buttons
to set the
schedule
time
3.Press
PLAN
button
again
to
save
the
setting.
To
cancel,
set
the
number
to
"00:00".
Note:
When
you
set
the
clock time
or
schedule,
the
final
operation will
be
confirmed
by
beep sound from robot;
if no
tone received, your setting
is
unsuccessful.
To Next Page
Loading...
