Ilife V7s - Charging operation

Product Operating
Charging operation
1>. Put charging home base against the wall and
remove obstacles about 1 meter at two sides and about
2 meters forward.
Plug the adapter into the AC socket, and plug another end
into the charging home base, the power light on charging
home base will be ON
2>. Turn on the Power Switch on the bottom side of the robot, then light will flash.
(If no command received, the robot will turn to SLEEPING mode after 15 seconds.)
Caution: Before charging the robot, please make sure the power switch of the robot is
turned on, otherwise the robot cannot be charged.
3>. Charge the robot in either way as shown below:
A.Plug the adapter into the robot and outlet directly;
B.Press on JL button on the remote control to make robot return to charging home base for
For better extending battery life:
A.Before first use, charge the robot for 12 hours. When charging is finished, all light will
turn off.
B.ln normal use, always store the robot on charging home base with base powered by the
adaptor
C. If the robot is not used for long time, turn off the power switch button, and store the robot
in the dry place
D.When the schedule clean is set, please does not charge the robot by the adaptor
directly, please charge the robot through the charging home base.
E.Always keep the auto charging pin clean.
4>. Auto charging
The robot will automatically return to charging home base when battery is low. Please put
the charge home base in the wide place and against the wall. Guide the robot by the
direction buttons on the remote control, if there is the need.