ILMOR 2011 MV8 - Water Temperature; Oil Pressure

thealarmwillnotgooffagain.Ifthealarmsoundsatanyothertimeorforany
otherreason,contactanauthorizedILMORdealerbeforere-startingtheengine.
The alarm appears if the engine coolant exceeds 199 F. (93 C.) in an open
cooled engine or 239 F. (115 C.) in a closed cooled engine. If this occurs, return the engine
or engines to idle and check the water temperature gauge on the instrument panel and the sea
water pressure gauge. If the sea water pressure is normal (less than 5 psi at idle) the coolant
temperature should begin to return to normal. If the temperature continues to increase, shut
down the overheated engine immediately and take the boat to an authorized ILMOR dealer.
The alarm appears if the engine oil pressure falls below the recom-
mended value for the current engine speed. If this occurs, throttle back to idle and al-
low the pressure to return above the 10 psi level. If the pressure continues to decrease,
shut down the engine immediately. Check the engine oil level in the affected engine. If
the oil level is acceptable, it indicates a different issue that should be addressed by an
authorized ILMOR dealer.
Water Temperature
Oil Pressure
2011 ILMOR MV8 Owner’s Manual • Page 10