OPERATIONS
Connecting to the TE Controller
7/01 LDC-3700 Series 15
CHAPTER 2
Connecting one of the TEC output terminals to analog or digital ground causes
catastrophic damage to the instrument.
For the TEC connector, if any one terminal pin is grounded, then no other terminal pin can
be grounded. Do NOT connect the Sensor (−) and TE Module (−) to the same ground; damage
to the instrument and devices will occur.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
