INSTALLATION PROCEDURES
3-3
1. Leveling Dryer
To level dryer, place 4 – inches square metal shims or other suitable material under the base
pads. It is suggested that the dryer be tilted slightly to the rear.
2. If more headroom is needed when moving dryer into position, the top console (module) may
be removed.
To remove top console (module)
1) Disconnect the ground wire at the Rear Upper Left Hand Cover of Dryer.
2) Remove the six (6) set of nuts and washers holding the console (module) to base.
3) Open the control door / control panel and disconnect the white 15 – pin plug connector
located in the base of the control box.
4) Disconnect white plug connector located outside backside of the control box (provides
power to heat circuit).
5) Lift the console (module) off of the dryer base.
IMPORTANT: The dryer must be transported and handled in an upright position at all times.
Figure.3-3 Dryer Model 100 lb. Rear View to Remove Top Console (module)
To Next Page
Loading...
