INSTALLATION PROCEDURES
3-12
Figure.3-9 Multiple exhaust connection
1. Electrical Requirements
It is your responsibility to have all electrical connections made by a properly licensed and
competent electrician to assure that the electrical installation is adequate and conforms to local and
state regulations or codes. In the absence of such codes, all electrical connections, material, and
workmanship must conform to the applicable requirements of the National Electrical Code
ANSI/NFPA NO. 70 – LATEST EDITION, or in Canada, the Canadian Electrical Codes Parts
1 & 2 CSA C22.1 – 1990 or LATEST EDITION.
IMPORTANT: Failure to comply with these codes or ordinances, and / or the requirements
stipulated in this manual can result in personal injury or component failure.
NOTE: Component failure due to improper installation will. VOID THE WARRANTY.
Each dryer should be connected to an independently protected branch circuit. The dryer
must be connected with copper wire only. DO NOT use aluminum wire which could cause a fire
hazard. The copper conductor wire / cable must be of proper amp city and insulation in accordance
with electric codes for making all service connections.
NOTE: The use of aluminum wire will. VOID THE WARRANTY.
F. ELECTRICAL INFORMATION
To Next Page
Loading...
