Imax B6 Ultimate - Charging Lithium Battery in the S; Discharging of Lithium Battery

CHARGING LITHIUM BATTERY IN THE STORAGE MODE
At this screen, you can set up the current and voltage of the battery pack.
Charging and discharging will make the batteries come to the voltage
level of “storage” state.
This screen shows the real-time status charging. Press BATT
TYPE/STOP key once to stop the charge process.
Number
of
cells
DEC
-
Batt type
Stop
Elapsed
time
INC
+
Charge
or discharge
current
Supplied
capacity
DEC
Start
Enter
-
‘>3 seconds’
INC
+
Current
voltage
battery
Charging lithium battery in the storage mode
DISCHARGING OF LITHIUM BATTERY
Number
of
cells
DEC
-
Batt type
Stop
elapsed
time
INC
+
Battery
voltage
DEC
Start
Enter
-
‘>3 seconds’
INC
+
Discharged
capacity
The value of discharge current on the left can not exceed 1C, and the
value on the right can not be under the voltage recommended by the
manufacturer to avoid deep discharging. Press START/ENTER for more
than 3 seconds to start discharging.
This shows the real-time status of discharging, you can press BATT
TYPE/STOP key to stop discharging.
discharge
current
INC
The processor detects voltage of one cell is too low.
The 4th cell was damaged. The value of voltage may be zero if disconnection
occurs.
The processor monitors voltage of each cell when the battery packs are during its “storage” and
“discharging” process. If voltage of any cell is abnormal, iMAX will show error message
and terminate the program forcibly. So if there is battery damage or disconnection, you can see the
error message and press INC to know which cell is damaged.
B6 Ultimate
Voltage balancing and monitoring in the discharge process
Discharging of lithium battery
25 26
This is for charging or discharging Lithium battery not to be used for the time being. The program
will determine to charge or discharge the battery to the certain voltage depending on the voltage of
the battery at its initial stage. They are different from the type of the battery, 3.75V for LiIo, 3.85V
for LiPo and 3.3V for LiFe per cell. If the voltage of battery at its initial stage is over the voltage
level to storage, the program will start to discharge.