LITHIUM POLYMER BALANCE CHARGE PROGRAM
CONNECTION DIAGRAM
CONNECTING THE BATTERY
Important !!! Before connecting a battery it is absolutely essential to check one last time that you have set
the parameters correctly. If the settings are incorrect, the battery may be damaged, and could even burst
into flames or explode. To avoid short-circuits between the banana plugs, always connect the charge leads
to the charger first, and only then to the battery. Reverse the sequence when disconnecting the pack.
IMAX comes with male 4mm Bullet connectors attached to the power INPUT cables.
These cables are appropriate for attaching directly to most high-quality AC-DC power supply units,
such as eFUEL model PSU20A (13.8V, 20A). Also included are large Terminal Clips with matching
4mm female bullet connectors, for attaching directly to 12V car batteries. It is critically important that
you use either a fully charged 13.8 car battery or a high quality AC-DC power supply in the range of 11V
to18V DC output, with minimum current rating of 20A to insure reliable performance.
B6 Ultimate
CONNECTING THE CHARGER
4mm Bullet
Connectors
plugging
to eFUEL power
supply directly
Using terminal
clip attaching to
car battery
PROGRAM FLOW CHART
15 16
To Next Page
Loading...
