What to do if my Immergas VICTRIX EXA 24 X 1 ErP displays 'Block due to loss of continuous flame signal'?
If your Immergas Boiler shows 'Block due to loss of continuous flame signal' because the flame signal was lost repeatedly, press the Reset button. The boiler will then run a post-ventilation cycle before restarting.
What does it mean if my Immergas VICTRIX EXA 24 X 1 ErP experiences loss of flame signal?
If your Immergas Boiler experiences a loss of flame signal, it means the burner flame went out unexpectedly after the boiler ignited correctly. A new ignition attempt will be made, and if normal conditions are restored, the boiler will restart without needing a reset.
What does it mean when my Immergas Boiler shows a flue safety thermostat block?
If your Immergas Boiler blocks due to excessive flue gas overheating during normal operation, press the Reset button to resolve the issue.
What does 'High temperature block on return probe' mean for my Immergas VICTRIX EXA 24 X 1 ErP?
If your Immergas Boiler shows a high temperature block on the return probe, it means the heat exchanger return circuit has reached a temperature that is too high. Make sure that water circulates properly in the boiler and that the three-way valve works properly. Press the Reset button to eliminate it.
What to do if my Immergas VICTRIX EXA 24 X 1 ErP is blocked due to insufficient circulation?
If your Immergas Boiler is blocked due to insufficient circulation, which can occur due to overheating from low system circulation or a blocked pump, press the Reset button. Also, check that no shut-off devices are closed on the heating circuit and ensure the system is free of air. If the pump is blocked, free the pump.
What to do if my Immergas Boiler experiences a loss of remote control communication?
If your Immergas Boiler loses communication with the remote control, power cycle the boiler. If the Remote Control is still not detected on re-starting, the boiler will switch to local operating mode, i.e. using the controls on the control panel.
What to do if the Immergas Boiler system pressure is insufficient?
If the Immergas Boiler displays insufficient system pressure, it means the water pressure inside the central heating circuit isn't sufficient for proper operation. Check the boiler pressure gauge to ensure the system pressure is between 1 and 1.2 bar. If it's not, restore the correct pressure.
What to do if my Immergas VICTRIX EXA 24 X 1 ErP Boiler shows 'Contacts resistance block'?
If your Immergas Boiler displays a 'Contacts resistance block', the P.C.B. has detected an anomaly on the gas valve supply. Check the connection. The anomaly is detected and displayed only when there is a request. To fix this, press the Reset button.
What does 'Flue safety thermostat block' mean on my Immergas Boiler, and how to fix it?
If your Immergas boiler displays a 'Flue safety thermostat block', it signifies that a fault has caused excessive fuel gas overheating during normal operation. To resolve this, press the Reset button.
What to do if my Immergas Boiler shows a safety thermostat block (over-temperature)?
If your Immergas Boiler goes into overheating block, it means a fault caused excessive overheating internally during normal operation. To fix this, press the Reset button.
To Next Page
General