What does it mean if my Immergas Boiler displays 'Maximum N° of reset'?
If your Immergas Boiler displays 'Maximum N° of reset', it means you've reached the limit of allowed resets. You can reset the boiler 5 times consecutively, after which the function is blocked for one hour. You regain one attempt every hour, up to a maximum of 5 attempts. Switching the appliance off and on will restore the 5 attempts.
What does it mean if my Immergas Boiler displays 'Insufficient circulation'?
If your Immergas Boiler displays 'Insufficient circulation', it indicates overheating due to inadequate water circulation in the primary circuit. This can be caused by low system circulation. Check that no shut-off devices are closed on the heating circuit and ensure the system is free of air. Also, the pump may be blocked, so free the pump. To attempt to resolve this, press the Reset button.
What to do if my Immergas VICTRIX EXA 24 X 1 ErP shows 'Block for exceeding the maximum accumulated time, close gas valve opening'?
If your Immergas Boiler displays 'Block for exceeding the maximum accumulated time, close gas valve opening', it means the gas valve remained open longer than necessary without the boiler igniting. To fix this, press the Reset button.
What does it mean if my Immergas VICTRIX EXA 24 X 1 ErP displays 'High temperature block on return probe'?
If your Immergas Boiler displays 'High temperature block on return probe', the heat exchanger return circuit has reached a temperature that is too high. Ensure water circulates properly in the boiler and that the three-way valve is working correctly. To clear the block, press the Reset button.
What to do if my Immergas VICTRIX EXA 24 X 1 ErP Boiler loses remote control communication?
If your Immergas Boiler loses communication with the remote control, either an incompatible remote control is connected, or communication has been lost. Disconnect and reconnect the power to the boiler. If the Remote Control is still not detected on restarting, the boiler will switch to local operating mode, i.e. using the controls on the control panel. In this case the 'Central Heating' function cannot be activated.
Why does my Immergas VICTRIX EXA 24 X 1 ErP Boiler not start with a flow probe anomaly?
If your Immergas Boiler doesn't start and indicates a flow probe anomaly, it means the board has detected an issue with the flow NTC probe. The boiler does not start.
Why does my Immergas VICTRIX EXA 24 X 1 ErP Boiler not start with a return probe anomaly?
If your Immergas Boiler doesn't start and indicates a return probe anomaly, it means the board has detected an issue with the return NTC probe. The boiler does not start.
What does it mean if my Immergas VICTRIX EXA 24 X 1 ErP Boiler has a push button control panel anomaly?
If your Immergas Boiler indicates a push button control panel anomaly, the board has detected an issue with the pushbutton panel. If normal conditions are restored, the boiler restarts without needing a reset.
What does it mean if my Immergas VICTRIX EXA 24 X 1 ErP Boiler displays 'IMG Bus communication loss'?
If your Immergas Boiler displays 'IMG Bus communication loss', communication between the components is interrupted due to an anomaly on the boiler control unit, on the zone control unit or on the IMG Bus. The boiler will not satisfy the room heating requests.
What happens if my Immergas Boiler has low power supply voltage?
If your Immergas Boiler experiences low power supply voltage, it means the voltage is below the required level for correct operation. If normal conditions are restored, the boiler restarts without needing a reset.
To Next Page
General