Seal the inner pane in the work area with sealant (s) again. After the assembly
of the panes and frame parts, the inner pane must be sealed using a sealant
(Terostat 930 gray is used at the factory). See Fig.:_06
8.
Example: G200.2 Work area door 03 1
Refit the front cover or front pane/design pane (a) and screw it on again on both
sides along the contour using the screws (M6 – 11 each).
Maintenance Summary - 8 Years
148
Maintenance Instructions
G200.3 G220.3
DIE248EN - 15.08.2022
To Next Page
