CM028 - Check hydraulic system
Carrying out the maintenance activities described below requires
special knowledge. For this reason, these maintenance activities
must be carried out only by authorized personnel of the
manufacturer!
Orientation
To check the settings of the various components, they can be made
visible in the control system in the Sensor System area. Refer to the
section on the sensor system in the documentation Machine
Operation.
Operating fluids such as hydraulic fluids, cooling lubricants, lubricating greases/oils
are also subject to degradation or aging, and must therefore serviced, refilled or
replaced at regular intervals. The hydraulic fluid must be changed periodically to
ensure reliable operation of the machine. Review of the maintenance and service
logs.
Requirement
Example: Hydraulic unit MS40-8
a
Accumulator drain valve
b Pressure accumulator
1 Pressure gauge for system pressure
2 Hydrostatic pressure gauge
X Hydraulic fluid filter
Y Filter bowl
The maintenance of the hydraulic system requires the following auxiliary or working
equipment:
- servicing, testing and maintenance schedules/logs of the customer.
- Use an ample supply of cleaning rags – no cotton waste.
Maintenance Summary - 2.000 Operating hours
52
Maintenance Instructions
MS40-8
DIM078EN - 02.06.2020
To Next Page
Loading...
