Induction Solutions NPC-2006 - Appendix A-Se Ng up the Controller for a Run

30
30
Appendix A—Seng up the controller for a run
1—Creang and saving a user setup file to the PC.
A—Launch the Nitrous Power Controller soware.
Note—if you have the “Preferences‐>Load Last File on Startup” opon checked the setup file that was open the last me the soware
was used will automacally be opened when you launch the soware. If this opon is not selected a default setup will be opened.
B—Edit the setup as desired.
C—Save the setup to the PC using “File‐>Save File” or oponally click on the Save File icon on the toolbar. If the setup is being
saved for the first me you will be prompted to enter a filename before saving.
Note—if you want to save the setup file with a new name use “File‐>Save As” or oponally click on the Save As icon on the
toolbar.
3—Modifying a setup from the controller.
A—Connect the USB cable to the controller and the PC. Make sure the controller is powered up.
Note—you can look at the status bar at the boom of the soware window to see if the controller is connected.
B—Download the setup to the PC using “Controller‐>Download Setup to Controller” or oponally click on the Download Setup to Con‐
troller icon on the toolbar.
C—Watch the progress bar in the lower le corner to confirm download progress.
D—Click on “OK” when the download complete message is displayed.
E—Edit the setup as desired.
F—The setup may be saved to the PC using “File‐>Save File” or oponally click on the Save File icon on the toolbar.
G—Upload the setup to the controller using “Controller‐>Upload Setup to Controller” or oponally click on the Upload Setup to Con‐
troller icon on the toolbar.
D—Watch the progress bar in the lower le corner to confirm upload progress.
E—Click on “OK” when the upload complete message is displayed.
2—Upload a user setup to the controller from a saved file.
A—Open a setup file from the PC by using “File‐>Open File” or oponally click on the Open File icon on the toolbar.
B—Connect the USB cable to the controller and the PC. Make sure the controller is powered up.
Note—you can look at the status bar at the boom of the soware window to see if the controller is connected.
C—Upload the setup to the controller using “Controller‐>Upload Setup to Controller” or oponally click on the Upload Setup to Con‐
troller icon on the toolbar.
D—Watch the progress bar in the lower le corner to confirm upload progress.
E—Click on “OK” when the upload complete message is displayed.
Note—the PC is used to save many setup files, only one setup can be uploaded to the controller at a me.
F—The controller is now ready to use with the setup that was saved to the PC.