31
31
Appendix B—Typical procedure when making a run
A—Edit and upload a setup to the controller.
Important—it is the responsibility of the user to create a proper setup for their applicaon!
B—Perform any usual pre‐race preparaons, clean res, purge nitrous system, etc.
C—Make sure nitrous arming switch is on.
D—When the T‐Brake/Clutch Input is on the Acvaon Input will be ignored unl you release the trans brake or clutch.
Note—as long as the T‐Brake/Clutch Input is on you can go wide open for the launch without the progressive nitrous system starng.
Important—if you are using the T‐Brake/Clutch Input Delay Timer the T‐Brake/Clutch Input will be ignored aer the inial launch for
the amount of delay me set for this feature.
E—Stage the vehicle and launch.
F—The data log will begin recording once the data recording acvaon condions are met.
1—the default seng for data recording acvaon is the Acvaon Input only.
2—you may configure the controller to only begin recording when the Acvaon Input and the T‐Brake/Clutch are both on.
3—you may also configure the controller to begin recording based on engine rpm.
Please see the “Data Setup” tab for these opons.
G—Aer the run you may turn the power off to the controller. The data log will be saved in the controller even with no power for sev‐
eral years.
Note—if you start another run before downloading the data log it will be over wrien!
H—See “Appendix C—Retrieving data log aer a run” for more informaon.
To Next Page
Loading...