EasyManuals Logo

Industrial Data Systems IDS 410 User Manual

Default Icon
63 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
IDS 410/422 User's Manual
9
Connect IDS 410/422 to host device (optional)
The Serial Communications Port 2 (TB3) provides a continuous output of scale data. This is
used for connection to a host device such as a computer or to a remote display (scoreboard).
Continuous output transmission can be enabled or disabled and the
output format can be customized to interface with the host device (see OPERATIONS
PARAMETERS - Continuous TX2 Format, page 5-10). See the HARDWARE
INSTALLATION AND WIRING section (page 8-2) for pin assignments and sample cable
drawings.
Apply AC/DC Power to the IDS 410/422
Once you have connected the IDS 410/422 to the load cell and optional equipment, plug the
power cord into AC or DC power.
The IDS 410/422 has an onboard transformer for AC applications. Insert the power cord into the
AC socket-outlet and the unit will power up, the plug on the power supply cord is considered the
units disconect device. The socket-outlet shall be installed near the equipment and shall be easily
accessible.
For DC applications the motherboard is equipted with a 2 position terminal block marked “PWR-
DC” connect the positive source side to the terminal marked + and negative to the terminal
marked -. See the HARDWARE INSTALLATION AND WIRING section (page 8-1) for pin
assignments and a sample cable drawing.
On power-up, the IDS 410/422 performs the following tests:
1 A/D Conversion Test - the IDS 410/422 checks the A/D converter to verify that data
conversions are taking place.
2 Keyboard Scan - the keyboard is scanned to verify that no keys are engaged..
3 Memory Test - the IDS 410/422 displays "rtESt" while it performs a memory test on internal
memory. If a problem is encountered during the test, an error message is displayed.
4 Lamp Test - all segments on the numeric display and all LED's are turned on for 5 seconds.
5 Conversion Display - the IDS 410/422 displays "Ad xxx", where "xxx" is the conversion
count. This test takes approximately 10 seconds.
6 Stability Check - the IDS 410/422 displays "Cxxxx" where "xxxx" is the raw data difference
in load cell readings. The IDS 410/422 waits until the data difference is within a stable
range.To exit the above power on test functions, press the clear [ZERO] key. This is possible
only if the IDS 410/422 has not been locked. The IDS 410/422 is now ready for initialization,
calibration, and configuration.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Industrial Data Systems IDS 410 and is the answer not in the manual?

Industrial Data Systems IDS 410 Specifications

General IconGeneral
BrandIndustrial Data Systems
ModelIDS 410
CategoryAccessories
LanguageEnglish

Related product manuals