Figure 14 Downloading the project
8. Push the reset switch (SW2) on the CYHVPA-128K-32-001 Evaluation Board and then confirm that the LED
(D7) is blinking.
• Download the application using the onboard KitProg3
9. Connect the USB cable to the J4 of the CYHVPA-128K-32-001 Evaluation Board with the power supply
(See Figure 15). See the PSoC
™
HV PA Evaluation Board user guide (References) for more detailed
information.
Getting started with PSoC
™
HV PA family
3 Development environment and tools
Application note 25 002-30264 Rev. *B
2023-04-19
To Next Page
Loading...
