Select “units of measure”
⚫ Press M button to enter submenu of General Setting;
⚫ Select ‘Units of Measure’, press M button to its submenu;
⚫ Press ↑ and ↓ button to select measuring units,
press M button to confirm and save.
Reset to Factory settings
⚫ Press M button to enter submenu of General Setting;
⚫ Select “Factory Reset”, press M button to enter submenu of
this option;
⚫ Press ↑and↓button to select Yes or No. “Yes”
means reset to factory settings.
⚫ Press M button to confirm selection;
⚫ The scope will reboot when selected ‘Yes’;
⚫ Select ‘No’ will cancel all previous operations and exit to
upper menu.
The scope will reset to following default status when selected
‘Factory Reset’:
- Image mode: White Hot;
- Zeroing Range: A100
- Ultra-Clear mode: OFF;
- Digital Zoom: x1;
- Shutter Calibration: Automatic;
- Digital Compass: OFF
To Next Page
Loading...
Need help?
General
