➢ Install the battery pack by aiming the pin of battery pack to the groove of battery pack jar.
➢ When the battery pack is fully embedded into the shell of Rico, rotate the ring of battery pack
anticlockwise (12) to lock the battery pack;
➢ Then the ring (12) is now vertical with battery pack, flip down the ring. When the raised part of
ring pointing to the sign “CLOSE” on battery pack, the installation of battery pack complete.
➢ Rico series only supports charging provided battery pack. Charging with unofficial battery pack
may cause damage to the device and fire, lead to extensive losses.
Safety Masures
⚫ Partial charging the battery is necessary if the battery is planned to be idled for long time. Avid
fully charged or discharged.
⚫ Don’t charge the battery instantly while bring the battery from cold environment to warm
environment. Leave 30-40 mins before charging;
⚫ Don’t leave battery unsupervised when charging;
⚫ Don’t charge with broken or modified charger;
⚫ Charge the battery in temperature range 0℃~+45℃, otherwise that may cause
short service life of battery.
⚫ Don’t charge over 24 hours;
⚫ Avoid battery contacting high temperature or fire;
⚫ Keep battery away from water;
⚫ Don’t charge with charger that has exceed rated current;
⚫ Avoid short circuit even though short circuit protection already included in battery pack;
⚫ Don’t disassemble and replace parts of battery pack; don’t hit the pack or fall it on the ground;
⚫ The battery capacity may decrease when operating in temperature below 0 ℃,that is normal,
not defect.
⚫ Avoid operating in temperature above 50℃, may lead to shorter battery service life.
⚫ Leave the battery pack to somewhere children can not access to.
7.External Power Supply
Rico series can be charged with external power supply, such as power bank.
➢ Plug in external power supply to the Type C port in Rico series scope;
➢ The device will switch to external power supply meanwhile charge battery pack.
To Next Page
Loading...
Need help?
General
