EasyManuals Logo

InfiRay Rico Series User Manual

InfiRay Rico Series
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
The icon of battery on the screen will turn into charging icon ;
If connected with external power supply but without battery pack, the icon of battery turns into
USB icon ;
While disconnect with external power supply, the Rico series will switch to internal power supply:
battery pack, instead of Turn OFF the scope.
Caution:
Charging IBP-1 pack in temperature blow 0 with power bank may lead to shorter
battery service life.
8. Operating
Picatinny Rail Installation
Before using the Rico series infrared scope, you need to install the Picatinny Rail on the bottom of
scope. Depend on the types of rifle, there are multiple screw locations to choose. Adjust to suitable
eye-relief distance.
Fix Picatinny rail on bottom of the scope with M5 screws;
Mount the scope on rifle and adjust to suitable location;
When the location is set, demount the scope and unscrew the screws, spread sealant on the
thread of screws, then screw them back. Leave the sealant to dry.
While the sealant is dry, mount the scope to rifle and start set zeroing;
Follow Step 9 as below to zeroing, if that is your first time to mount on rifle.
Warning! Don’t point the lens towards any intense light source, such as laser or solar. This may
break the scope and damaged devices in that case are not covered by warranty.
Turn On
Open the lid of lens, hold down the power button to turn on the scope. Wait for seconds
before the scope finish starting up.
Rotate diopter regulation knob until images in eyepiece are clear. When next time the same
user using the scope, there is no more adjustment required once the regulation was set.
Rotate the focusing ring of object lens until the object is focused and clear.
Refer to shortcut menu instructions of this manual to set the following parameters:

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the InfiRay Rico Series and is the answer not in the manual?

InfiRay Rico Series Specifications

General IconGeneral
Pixel Size12 μm
NETD<25 mK
Frame Rate50 Hz
WaterproofIP67
Display Resolution1024x768
Battery Life6 hours
Objective Lens Diameter19mm

Related product manuals