10
Adjusting the image
If necessary, adjust the height of the projector by rotating the elevator foot to extend
the foot.
If necessary, rotate the leveling foot located at the rear of the projector.
Avoid placing your hands near
the hot exhaust vent at the front of the projector.
Position the projector the desired distance
from the screen at a 90 degree angle to
the screen.
See page 6 for a table listing scree
n sizes and distances.
Adjust the zoom or focus.
If the image is not square, first make sure tha
t the projector is perpendicular to the
screen. If the image is larger or smaller on the top or bottom edge of the screen,
press the top Keystone button to
reduce the upper part of the image, and press
the bottom Keystone button to reduce the lower part.
If the left or right side of the screen is lar
ger or smaller the other, you can turn the
projector to the left or to the right a few degrees to square the image.
Adjust the Contrast or Brightness in the
Basic Menu. See page 26 for help with
these menu adjustments.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
