Image is out of focus
4
Make sure the Lens cap is removed.
4
Adjust the Focus Ring on the projector lens.
4
Make sure the projection screen is between the required distance.
See pages 16-17.
The image is stretched when displaying 16:9 DVD title
4
When you play anamorphic DVD or 16:9 DVD, the projector will
show the best image when the projector display mode is set to
16:9 in the OSD.
4
If you play 4:3 format DVD titles, please change the format to 4:3
in the projector OSD.
4
If the image is still stretched, you will also need to adjust the
aspect ratio by referring to the following:
4
Please setup the display format as 16:9 (wide) aspect ratio type
on your DVD player.
Image is too small or too large
4
Adjust the Zoom Ring on the top of the projector.
4
Move the projector closer to or further from the screen.
4
Press “Menu” button on the remote control, go to “Display
Format” and try the different settings.
Image has slanted sides
4
If possible, reposition the projector so that it is horizontally
centered on the screen and below the bottom of the screen.
4
Press “Keystone +/-” button on the remote control until the sides
are vertical.
4
Use “Display
V Keystone” from the OSD to make an adjust-
ment.
Image is reversed
4
Select “SETUP
Projection” from the OSD and adjust the
projection direction.
Use of Keystone
is not recom-
mended.
To Next Page
Loading...
