InFocus in3138hd - LED Error Messages

IN3138HD User’s Manual
– 47 –
LED Error Messages
ERROR CODE MESSAGES
POWER LED
BLUE
LAMP LED
RED
Lamp On ON OFF
Powering up Flashing OFF
Powering/Cooling down Flashing OFF
Overheating OFF OFF
T1 error 3 blinks 1 blinks
Thermal break sensor error 4 blinks OFF
G794 error 4 blinks 4 blinks
Lamp failure 5 blinks OFF
Ballast overheating 5 blinks 1 blinks
Ballast circuit short 5 blinks 2 blinks
Lamp end of life detected 5 blinks 3 blinks
Lamp did not ignite 5 blinks 4 blinks
Lamp extinguished during normal operation 5 blinks 5 blinks
Lamp extinguished during power-up phase 5 blinks 6 blinks
Lamp voltage too low 5 blinks 7 blinks
Ballast failure 5 blinks 8 blinks
Ballast communication failure 5 blinks 10 blinks
Ballast overheating 5 blinks 11 blinks
Restrike lamp failure 1 5 blinks 12 blinks
Restrike lamp failure 2 5 blinks 13 blinks
Lamp failure1 5 blinks 14 blinks
Lamp failure2 5 blinks 15 blinks
Fan 1 error 6 blinks 1 blinks
Fan 2 error 6 blinks 2 blinks
Fan 3 error 6 blinks 3 blinks
Fan 4 error 6 blinks 4 blinks
The projector case is open 7 blinks OFF
DMD error 8 blinks OFF
Color wheel error 9 blinks OFF
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before restarting
the projector. If the Power or Lamp LEDs are still blinking or any other situation that isn't listed in the chart
above
, please contact InFocus Support.