24
Using the remote control
The remote uses two (2) AA batteries (not provided). They are easily installed by
removing the cover from the remote’s back, aligning the + and - ends of the
batteries, sliding them into place, and then replacing the cover.
Caution:
• When replacing the remote batteries, be aware that using batteries other
than
AA batteries may risk severe damage to the remote. When disposing of the
batteries, be sure to do so in an enviromentally proper manner.
• If the remote control gets wet, wipe it dry immediately.
•
Avoid excessive heat and humidity.
• Ensure the batteries' polarity (+/-) is aligned correctly.
• Do not mix new and old batteries together, or mix different types of batteries
together.
• Replace the batteries as soon as they run out.
• Remove batteries from the remote control when storing or not in use for a pro-
longed period.
To operate, point the remote at the front of the
projector (not at the computer). The
range of optimum operation is about 15 feet (4.5m).
Press the remote’s Power button to turn the projector on and off (see page 12 for
shutdown info).
Press the remote’s Me
nu button to open the projector’s menu system. Use the arrow
buttons to navigate, and the Select button to select features and adjust values in the
menus. See page 30 for more info on the menus.
The remote also has:
• Vol ume buttons to adjust the sound.
• Cus
tom button that can be assigned to a special function, like Blank Screen or
Freeze (see page 33).
• Sour
ce button to switch between sources.
• Blank button
to blank the screen.
• Presets button to select stored settings (see page 31).
• Mu
te button to silence the audio.
• Aut
o Image button to resynch the projector to the source.
• Resize button to switch among aspect ratios (see page 31).
• He
lp button to get help with connecting sources and improving the picture.
Troubleshooting the remote
• Make sure the batteries are installed in the proper orientation and are not dead.
• Make sure you’re pointing the remote at the
projector or the screen, not the
computer, and are within the remote range of 15 feet (4.5m). For best results,
point the remote at the projector.
To Next Page
Loading...
Need help?
General
