11
Displaying an image
Touch the Power button on the keypad or the remote.
The Power button blinks green, a beep
will sound and the fans start to run. When
the lamp turns on, the start up screen will display and the Power button will become
solid green. It can take a minute for the image to achieve full brightness.
No start up screen? Get help on page 16.
Turn on your computer or video device.
The image should appear on the
projection screen. If it doesn’t, press the Source
button on the projector’s keypad or remote.
If you are using a VGA cable to connect your computer to the projector (instead
of
DisplayLink):
If using a laptop, make sure its external video
port is active.
Many laptops do not automatica
lly turn on their external video port when a
projector is connected. Usually a key combination like Fn + F8 or CRT/LCD key
turns the external display on and off. Locate a function key labeled CRT/LCD or a
function key with a monitor symbol. Press Fn and the labeled function key
simultaneously.
Refer to your laptop’s documentation for more information abou
t your laptop’s key
combination or go to the InFocus website at:
http://www.infocus.com/Support
/LaptopActivation.aspx.
No laptop image? T
ry pressing the Auto Image button on the keypad or
remote. Get help on page 25.
Is your laptop connected to the projec
tor's DisplayLink connector? See
the InFocus DisplayLink Software User's Guide (available on the InFocus
website at www.infocus.com/displaylink) for troubleshooting information.
To Next Page
Loading...
Need help?
General
