15
Shutting down the projector
Screen Save Time
You can make the black screen appear after a preset number of minutes by turning
on the Screen Save Time feature in the Setup menu. See page 30.
Auto Off Time
The projector has an Auto Off Time feature that automatically turns the projector
off if no active sources are detected and no user interaction with the projector is
performed for 30 minutes. By default, this feature is off. You can change the length
of time, see page 30.
Turning off the projector
To turn the projector off, press the Power button on the remote or keypad. The lamp
turns off, a beep sounds and the LED blinks amber for 10 seconds while the fans
continue to run to cool the lamp. When the lamp has cooled, the LED lights amber
and the fans stop. Unplug the power cable to completely power off the projector.
Troubleshooting your setup
The Status Indicator Panel on top of the projector indicates the state of the projector
and is helpful when troubleshooting
.
Table 1: Status indicator light behavior and meaning
Icon Meaning
Power, solid amber
Power, blinking green
Power, solid green
Power, blinking amber
The projector is plugged in.
The power button has been pressed and the software is
initializing.
The projector is on and initialized.
The power button has been pressed to turn the projector off
and
the fans are running to cool the projector.
Temperature
The projector is too hot. Make sure the vents aren’t blocked
(see page 21). Turn the projector off and wait one minute,
then turn the projector on again.
Contact Technical Support if
the problem persists. Visit www.infocus.com/support to
contact service.
Lamp
Turn the projector off and wait one minute, then turn the
projector on again. If the lamp light turns on again, replace
the lamp and reset the lamp timer
(page 43).
Note: On
e blink off every 2 seconds means the problem is
with lamp #1; two blinks off every 2 seconds means the
problem is with lamp #2.
Wrench/Service
Turn the projector off and wait one minute, then turn the
projector on again. If the service lamp turns on again, service
is required. Visit www.infocus.com/support to contact
service.
To Next Page
Loading...
Need help?
General
