Setting up the LitePro 580
20 LitePro 580 User’s Guide
5. Adjust sync or brightness to fine tune the image.
6. Adjust the volume with the volume control on the projector or
the remote control if you have audio input.
Turning off the LitePro
If you want to turn off the projector for a short period of time, press
the Standby button on the projector or the remote control. This turns
off the lamp but keeps the projector running.
To completely power off the projector, turn the power switch off. If
you want to turn the projector back on immediately, you must allow
from 10 to 60 seconds for the lamp to cool. The lamp will not light if it
is too hot.
Each time you power off the projector, its settings are retained in
memory. These settings are then available to you the next time you
turn on the projector.
Be very careful not to look directly into the lens
when the projector is turned on. The bright light may
harm your eyes. Be especially careful to keep
children from looking into the lens.
To Next Page
Loading...
Need help?
General