What to do if my INFOSEC UPS is overloaded?
If your INFOSEC UPS is overloaded, remove some of the devices connected to its output. If, after repetitive overloads, the UPS is locked on Bypass mode (connected devices are fed directly by the mains), first remove excess loads from the UPS output, then shut down the UPS and restart it.
How to fix fault code 43 on my INFOSEC UPS?
Fault code 43 indicates that the INFOSEC UPS has been overloaded for too long and has become faulty, causing it to shut down automatically. To resolve this, remove excess loads from the UPS output and then restart the UPS.
What to do if my INFOSEC E4 Value UPS shows fault code 14?
Fault code 14 indicates that a short circuit occurred on the UPS output, causing the INFOSEC UPS to shut down automatically. You should check the output wiring and ensure that none of the connected devices are causing a short circuit.
Why is my INFOSEC UPS battery backup time so short?
A shorter than expected battery backup time on your INFOSEC UPS can be due to a few reasons. The batteries may not be fully charged. Charge the batteries for at least 7 hours and then check their capacity. If the problem persists, consult your dealer. Another potential cause is a defective battery.
How to troubleshoot no display on my INFOSEC E4 Value?
If there is no display or alarm on the front panel of your INFOSEC UPS, even when the mains power is normal, the AC input power may not be connected properly. Check that the input cable is firmly connected to the mains.
Instructions and precautions for installing the UPS unit.
Procedures and precautions for operating the UPS system.
Critical warnings and precautions for connecting the UPS system.
Detailed instructions for installing a single UPS unit and wiring.
Step-by-step guide for operating the UPS in different modes.
Detailed safety precautions and procedures for UPS maintenance.
To Next Page
General