3
Credit Transactions To initiate
Credit Sale* A sale transaction using a credit
card; the card may or may not be present.
Swipe the card
and then select
CREDIT CARD.
Or, select
CREDIT CARD
and then select
SALE.
Auth Only* An authorization-only transaction
provides an approval, but does not charge the
consumer until the transaction has been added
to the batch by way of a force transaction.
Select CREDIT
CARD and then
select AUTH
ONLY.
Force* Perform a force sale when the terminal
cannot reach the host (Chase Paymentech) to
authorize a transaction, or to finalize an Auth
Only transaction. Contact your voice
authorization center for an authorization code,
and then force the transaction.
Select CREDIT
CARD and then
select FORCE.
Return* Perform a return to refund money to
a cardholder’s account from a credit sale
completed in a closed batch (i.e., previous
day). May also be used to adjust a previous
transaction.
Select CREDIT
CARD and then
select RETURN.
Void* Perform a void to reverse a credit sale,
force, or return transaction and prevent any
funds from transferring from the cardholder’s
account. Only available for transactions in the
current batch (i.e., same day).
Select CREDIT
CARD and then
select VOID.
Pay@Table (i7780 restaurant only) Allows
the terminal to be handed to the cardholder to
swipe the credit or debit card and confirm any
prompts while still being in possession of the
card.
Select PAY AT
TABLE.
Open/Close Tab (restaurant only) A pre-
authorization transaction for a specific,
predetermined dollar amount.
Select CREDIT
CARD and then
select TAB.
Available
Transaction
Types
Your terminal
supports various
transaction types.
Refer to this section for
information on what
transactions are
available, when to use
them, and how to begin
the transaction.
*Purchase and Commercial
cards are supported for this
transaction type.
To Next Page
Loading...
