11
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
15.19 (a) (3)
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
1) This device may not cause harmful interference and
2) This device must accept any interference received, including
interference that may cause undesired operation of the device.
3_4_2 Industry Canada (IC) Statement.
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
1) this device may not cause interference, and
2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes:
1) l’appareil ne doit pas produire de brouillage, et
2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
Changes or modications made to this equipment not expressly
approved by (manufacturer name) may void the FCC authorization to
operate this equipment.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
3_4_3 FCC/IC RF Exposure (SAR)
Statement.
The ISMP4, has been tested and meets applicable limits for radio
frequency (RF) exposure. Specic Absorption Rate (SAR) refers to the
rate at which the body absorbs RF energy. The SAR limit is 1.6 watts
per kilogram averaged over 1 gram of tissue. Carry the ISMP4 at least
To Next Page