100Base-TX cross-over cable
5.2 100Base-FX port
Carefully plug in the optical cables and polish the connectors if nessecary. Rough
handling and repeated use can damage the cable and connectors.
Ensure that both ends of the fiberoptic cable are correctly wired. The Tx port of the
home terminal shall be connected to Rx port of the opposite terminal, and the Rx of
the home terminal shall be connected to Tx port of the opposite terminal. Here, the SC
port is used as an example for wiring optical cable connections. The process for
connecting ST, FC and LC cables are the same as SC.
Attention:
When both ends of the fiberoptic cable are plugged in, but the port LEDs do
not blink, check that the wiring is correct. The Rx and Tx cables may be
switched.
5.3 1000Base-X, 1000Base-T(X) SFP Port
The SFP port supports either a gigabit SFP optical module (1000Base-X) or gigabit
SFP electric module, 1000Base-T(X), depending on network requirements.
To Next Page
Loading...