Gigabit SFP electric module
Typical gigabit SFP electric module is shown in the following diagram.
The steps for connecting network cables to an SFP electric module are as follows:
Step 1: Plug the SFP electric module into the SFP slot.
Step 2: Connect both ends with an Ethernet cable.
Attention:
CAT5, CAT6 or CAT7 types of twisted pair cable shall be used.
5.4 Power Source
The InSwitch ISE series allow for dual redundant power supplies on it’s industrial
terminal block. Dual power supply connections allow users to provide more
redundancy and fallback options for important nodes. The terminal block allows
industrial and electric power users to employ the existing power supply in an
enclosure. Simply wire the power supply’s positive negative and ground into the
power terminal to power on the switch.
To Next Page
Loading...