INIM Electronics Prime Series

28 The control panel and peripherals
Anti-intrusion control panels
KNX INTERFACE PrimeLAN allows the Prime control panel to interface with systems that use the KNX protocol
via the LAN.
When programming the control panel via software/STUDIO it is possible to translate
commands and events into specific signals from and to the KNX system.
However, it is necessary to use a KNX/IP interface, KNX device to be connected to the LAN and
to the KNX BUS.
Table 2-33: PrimeLAN - description of parts
A Connectors for the motherboard (on the back)
B Connector for the optional board
C RESET button
D HARD RESET button
E μSD-card connector
F LED - Board power
G LED - Connection between control panel and board
H Mounting screw hole
E
F
D
A B
C
G
A
H
HH
H