Installation manual
Installation 47
3-10-2
PrimeLAN
The picture opposite shows the PrimeLAN mounted inside the enclosure. If you intend
installing this board, work carefully through the following steps.
1. Disconnect the primary power supply to the control (230V~) and the buffer battery.
2. Remove the 4 screws from the motherboard fixing holes that coincide with the holes for
the optional board (Table 2-6: Mother board - description of parts, G).
3. Replace the screws with the threaded metal spacers (supplied with the PrimeLAN
board).
4. Insert the board making sure that the connectors on the back (Table 2-33: PrimeLAN -
description of parts, A) coincide with the appropriate ones on the motherboard (Table
2-6: Mother board - description of parts, F).
5. Fix the 4 screws into the holes in correspondence with the spacers ([A], Table 2-33:
PrimeLAN - description of parts, H).
6. Power up the control panel by reconnecting the mains power (230V
~) and backup bat-
tery.
Note
It is important to note that the e-mail service does not guarantee delivery time of e-mails and their
attachments nor even their final delivery.
A
A
A
A
To Next Page
Loading...
