50 First operational test
Anti-intrusion control panels
DIALER TEST
9. The control panel will carry out signalling by means of a voice call to the programmed
number.
10. Perform a disarm partitions operation. This operation also stops any alarms.
If the default programming has not been changed, it can be carried out as described
below, following entry of the user code:
Via keypad
Activate the shortcut associated with button shown on the display. The shortcut will
carry out a “Disarm” operation.
Via Alien
Press the Scenarios button. This section provides a list of the scenarios, activate scenario 2
“Disarm” by pressing the ACTIVATE button.
11. Delete alarm memories.
If the default programming has not been changed, it can be carried out as described
below, following entry of the user code:
Via keypad
Activate the “Delete memory” shortcut (shortcut no. 4) associated with the button
shown on the display.
Via Alien
Press the Menu button, access the “Actions” section then press the ON button that
corresponds to the “Delete alarm memory” operation.
Performing all the phases described above on a regular basis without problems is sufficient to
confirm proper functioning and correct basic programming of the control panel.
To Next Page
Loading...
