– Endogenous gases.
The RF energy and heating associated with the System can provide an
ignition source. Observe fire precautions at all times. When using InMode
System with Morpheus8 Body Handpiece in the same room with any of
these substances or gases, prevent their accumulation or pooling within the
area where Morpheus8 Body procedures are performed.
The operation of the InMode System with Morpheus8 Body Handpiece may
adversely influence the operation of other electronic EQUIPMENT.
To avoid the RISK of electric shock, this equipment must only be connected
to a SUPPLY MAINS with protective earth.
2.9 Handpiece Label
As required by national and international regulatory agencies, appropriate warning
and information labels have been attached in specific locations on the instrument as
identified below.
The Handpiece certifications and identification labels are attached to connectors on
the Handpieces. It states that the product conforms to the performance standards,
and indicates the manufacturer’s name, date of manufacturing, model and serial
number of the Handpiece. The following labels are located on the Handpiece:
Manufacturer identification labeling is placed on the Handpiece:
Figure 2-1: Morpheus8 Body Handpieces Identification Label
To Next Page
Loading...
