InMode Morpheus8 - Section 4: Device Description; Rear Panel

Morpheus8 Body Applicator Operator
Manual
Section 4: Device Description
11 of 34
Section 4: Device Description
4.1 Rear Panel
Power Cord Inlet
100-240V~, 15A, 50-60Hz.
Fuse Holder
Rating is T 12A, 250V. Replace fuses if needed, only with fuses having
exactly the same rating.
Software Flash Memory Plug
The software plug is a flash memory with the machine software. The
software plug should be screwed to the connectors. To tighten and/or
loosen the screws use fingertips only. Do not use screwdriver as it can
damage the connectors.
Footswitch Connector
Footswitch is connected to the inlet. Footswitch activates RF energy if
the System is in Ready mode. Place the Footswitch on the floor near
the treatment area.
!!
