▪ Apply anesthesia:
– Topical anesthetic can be applied as needed prior to treatment.
▪ Cooling methods, such as air cooling, sterile ice-packs, or sterile latex gloves filled
with ice, help patient comfort during and after treatment.
The patient should shave the area to be treated. Long and dense hairs
prevent electrode contact with the skin’s surface.
The Morpheus8 tip arrives gamma-sterilized and is single use only! These
tips SHOULD NOT be autoclaved or re-sterilized by any other technology!
When choose "Fractional" on Menu Screen, the connected Morpheus8
Body handpiece with tip is performing self -test. The pins go out and in, as
the Treatment Screen opens. It is crucial to avoid touching the skin with the
tip at this stage and leave the Handpiece in its cradle.
The operator shall wear surgical gloves (single use only)
6.6 Test Spots
A small test spot should be performed in a non-conspicuous area of the treatment
site, prior to the first complete session. Test spot is performed to establish the
following requirements:
▪ Confirm the patient's suitability for treatment:
– For skin types I – III wait 10-15 minutes before assessing the skin
response.
– For skin types V-VI wait 2-3 days.
▪ Establish and confirm treatment parameters: if the desired end-point of
erythema and edema – in a tip-shaped pattern – has not been achieved within
10-15 minutes, increase the RF energy. If the response is excessive, decrease the
parameters.
To Next Page
Loading...
